Ads
related to: wire rope long splicing
Search results
Results From The WOW.Com Content Network
The long splice, unlike most splice types, results in a splice that is only very slightly thicker than the rope without the splice, but sacrifices some of the strength of the short splice. It does this by replacing two of the strands of each rope end with those from the other, and cutting off some of the extra strands that result.
A short fid is 1 ⁄ 3 a fid length and a long fid is 2 ⁄ 3 the overall fid length. Modern major rope manufacturers such as Yale Cordage, [1] New England Ropes, [2] and Samson Rope Technologies [3] each have full sets of published splicing directions available on their websites. Typically, all splice directions measurements use fid-length as ...
In stricter senses, the term wire rope refers to a diameter larger than 9.5 mm (3 ⁄ 8 in), with smaller gauges designated cable or cords. [1] Initially wrought iron wires were used, but today steel is the main material used for wire ropes. Historically, wire rope evolved from wrought iron chains, which had a record of mechanical failure.
The eye splice is a method of creating a permanent loop (an "eye") in the end of a rope by means of rope splicing. The Flemish eye is a type of circular loop at the end of a thread. There are several techniques of creating the eye with its knot tied back to the line, rope or wire.
This allowed for long ropes of up to 300 yards (270 m) long or longer to be made. These long ropes were necessary in shipping as short ropes would require splicing to make them long enough to use for sheets and halyards. The strongest form of splicing is the short splice, which doubles the cross-sectional area of the rope at the area of the ...
The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...