When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Rockwell hardness test - Wikipedia

   en.wikipedia.org/wiki/Rockwell_hardness_test

   Very hard steel (e.g. chisels, quality knife blades): HRC 55–66 (Hardened High Speed Carbon and Tool Steels such as M2, W2, O1, CPM-M4, and D2, as well as many of the newer powder metallurgy Stainless Steels such as CPM-S30V, CPM-154, ZDP-189. There are alloys that hold a HRC upwards 68-70, such as the Hitachi developed HAP72.

3. Pitting resistance equivalent number - Wikipedia

   en.wikipedia.org/wiki/Pitting_Resistance...

   In general: the higher PREN-value, the more resistant is the stainless steel to localized pitting corrosion by chloride. PREN is frequently specified when stainless steels will be exposed to seawater or other high chloride solutions. In some instances stainless steels with PREN-values > 32 may provide useful resistance to pitting corrosion in ...

4. Sink - Wikipedia

   en.wikipedia.org/wiki/Sink

   Stainless steel sinks are widely celebrated for their durability, sleek appearance, and resistance to rust and corrosion. However, many homeowners are baffled when they spot rust stains on their stainless steel sink. [3] One disadvantage of stainless steel is that, being made of thin metal, they tend to be noisier than most other sink materials ...

5. Duplex stainless steel - Wikipedia

   en.wikipedia.org/wiki/Duplex_Stainless_Steel

   Duplex steels also have higher strength. For example, a Type 304 stainless steel has a 0.2% proof strength in the region of 280 MPa (41 ksi), a 22%Cr duplex stainless steel a minimum 0.2% proof strength of some 450 MPa (65 ksi) and a superduplex grade a minimum of 550 MPa (80 ksi). [6]

6. Heat sink - Wikipedia

   en.wikipedia.org/wiki/Heat_sink

   [25] The heat sink thermal resistance model consists of two resistances, namely the resistance in the heat sink base, , and the resistance in the fins, . The heat sink base thermal resistance, , can be written as follows if the source is a uniformly applied the heat sink base. If it is not, then the base resistance is primarily spreading ...

7. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Side and end view of a 4-fluted countersink. The fluted countersink cutter is used to provide a heavy chamfer in the entrance to a drilled hole. This may be required to allow the correct seating for a countersunk-head screw or to provide the lead in for a second machining operation such as tapping.