Ads
related to: why use surge protection devices explained
Search results
Results From The WOW.Com Content Network
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD) or transient voltage surge suppressor (TVSS) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes with very short duration measured in ...
Modern varistor schematic symbol, which is the same as a thermistor symbol [ 1 ] A varistor (a.k.a. voltage-dependent resistor (VDR)) is a surge protecting electronic component with an electrical resistance that varies with the applied voltage. [ 2 ] It has a nonlinear, non- ohmic current–voltage characteristic that is similar to that of a diode.
Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.
In addition to creating more plug-in opportunities, surge protectors help fortify your plugged-in devices from a surge in the electric power supply by preventing it from sizzling your beloved gadgets.
IEC 61000-4-5 defines test set-up, procedures, and classification levels. In particular, it standardizes the required surge voltage and current waveforms for laboratory testing, with the "1.2/50-8/20 μs" impulse being the most frequently used surge waveform. Although this standard is designed for testing equipment as a whole at system level ...
Surge control. Surge control is the use of different techniques and equipment in a hydraulic system to prevent any excessive gain in pressure (also known as a pressure surge) that would cause the hydraulic process pressure to exceed the maximum working pressure of the mechanical equipment used in the system.
The most popular application is the inrush protection of the AC current in switching power supplies (SPS). The primary reason for having surge current suppression in a SPS is to protect the diode bridge rectifier as the input or charging capacitor is initially charged. This capacitor draws significant current during the first half AC cycle and ...
Power system protection. Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by ...