Search results
Results From The WOW.Com Content Network
Voltage standing wave ratio (VSWR) (pronounced "vizwar" [1][2]) is the ratio of maximum to minimum voltage on a transmission line . For example, a VSWR of 1.2 means a peak voltage 1.2 times the minimum voltage along that line, if the line is at least one half wavelength long. A SWR can be also defined as the ratio of the maximum amplitude to ...
For example, the SWR bandwidth is typically determined by measuring the frequency range where the SWR is less than 2:1 . Another frequently used value for determining bandwidth for resonant antennas is the −3 dB return loss value, since loss due to SWR is −10·log 10 (2÷1) = −3.01000 dB.
A standing wave ratio meter, SWR meter, ISWR meter (current " I " SWR), or VSWR meter (voltage SWR) measures the standing wave ratio (SWR) in a transmission line. [a] The meter indirectly measures the degree of mismatch between a transmission line and its load (usually an antenna). Electronics technicians use it to adjust radio transmitters and ...
Cross-needle SWR meter on antenna tuner. It is a common misconception that a high standing wave ratio (SWR) per se causes loss. [3] A well-adjusted ATU feeding an antenna through a low-loss line may have only a small percentage of additional loss compared with an intrinsically matched antenna, even with a high SWR (4:1, for example). [21]
While having a one-to-one correspondence with reflection coefficient, SWR is the most commonly used figure of merit in describing the mismatch affecting a radio antenna or antenna system. It is most often measured at the transmitter side of a transmission line, but having, as explained, the same value as would be measured at the antenna (load ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
Radiation resistance is that part of an antenna 's feedpoint electrical resistance caused by the emission of radio waves from the antenna. [a][1][2] A radio transmitter applies a radio frequency alternating current to an antenna, which radiates the energy of the current as radio waves. Because the antenna is absorbing the energy it is radiating ...
Standing wave. Animation of a standing wave (red) created by the superposition of a left traveling (blue) and right traveling (green) wave. In physics, a standing wave, also known as a stationary wave, is a wave that oscillates in time but whose peak amplitude profile does not move in space. The peak amplitude of the wave oscillations at any ...