Ads
related to: elevated elevator control surface
Search results
Results From The WOW.Com Content Network
Elevators' effect on pitch Elevator and pitch trim tab of a light aircraft. Elevators are flight control surfaces, usually at the rear of an aircraft, which control the aircraft's pitch, and therefore the angle of attack and the lift of the wing. The elevators are usually hinged to the tailplane or horizontal stabilizer.
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
Another common high-lift device is the slat, a small aerofoil shaped device attached just in front of the wing leading edge. The slat re-directs the airflow at the front of the wing, allowing it to flow more smoothly over the upper surface when at a high angle of attack. This allows the wing to be operated effectively at the higher angles ...
X-53 Active Aeroelastic Wing in flight. Several technology research and development efforts exist to integrate the functions of aircraft flight control systems such as ailerons, elevators, elevons and flaps into wings to perform the aerodynamic purpose with the advantages of less: mass, cost, drag, inertia (for faster, stronger control response), complexity (mechanically simpler, fewer moving ...
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
The V-tail or vee-tail (sometimes called a butterfly tail [1] or Rudlicki's V-tail [2] [citation needed]) of an aircraft is an unconventional arrangement of the tail control surfaces that replaces the traditional vertical and horizontal surfaces with two surfaces set in a V-shaped configuration. It is not widely used in aircraft design.
Ad
related to: elevated elevator control surface