Search results
Results From The WOW.Com Content Network
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Inter-Switch Link (ISL) is a Cisco proprietary protocol used to interconnect switches and maintain VLAN information as traffic travels between switches on trunk links. ISL is provided as an alternative to IEEE 802.1Q. ISL is available only on some Cisco equipment and has been deprecated. [11]
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links. It is offered ...
The inside of a Cisco 1900-series switch. Catalyst is the brand for a variety of network switches, wireless controllers, and wireless access points sold by Cisco Systems.While commonly associated with Ethernet switches, a number of different types of network interfaces have been available throughout the history of the brand.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
A network switch is a multiport network bridge that uses MAC addresses to forward data at the data link layer (layer 2) of the OSI model. Some switches can also forward data at the network layer (layer 3) by additionally incorporating routing functionality. Such switches are commonly known as layer-3 switches or multilayer switches. [2]
This port communicates with P-Ports and ports on the same community VLAN. Example scenario: a switch with VLAN 100, converted into a Private VLAN with one P-Port, two I-Ports in Isolated VLAN 101 (Secondary) and two community VLANs 102 and 103 (Secondary), with 2 ports in each. The switch has one uplink port (trunk), connected to another switch.
Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2; Change the native VLAN on all trunk ports to an unused VLAN ID. Switch (config-if)# switchport trunk native vlan 999; Explicit tagging of the native VLAN on all trunk ports.