Search results
Results From The WOW.Com Content Network
11.6 g of NaCl is dissolved in 100 g of water. The final mass concentration ρ(NaCl) is ρ(NaCl) = 11.6 g / 11.6 g + 100 g = 0.104 g/g = 10.4 %. The volume of such a solution is 104.3mL (volume is directly observable); its density is calculated to be 1.07 (111.6g/104.3mL) The molar concentration of NaCl in the solution is therefore
Note: ρ is density, n is refractive index at 589 nm, [clarification needed] and η is viscosity, all at 20 °C; T eq is the equilibrium temperature between two phases: ice/liquid solution for T eq < 0–0.1 °C and NaCl/liquid solution for T eq above 0.1 °C.
Sodium chloride / ˌ s oʊ d i ə m ˈ k l ɔːr aɪ d /, [8] commonly known as edible salt, is an ionic compound with the chemical formula NaCl, representing a 1:1 ratio of sodium and chlorine ions. It is transparent or translucent, brittle, hygroscopic, and occurs as the mineral halite. In its edible form, it is commonly used as a condiment ...
In chemistry, the mass concentration ρ i (or γ i) is defined as the mass of a constituent m i divided by the volume of the mixture V. [1]= For a pure chemical the mass concentration equals its density (mass divided by volume); thus the mass concentration of a component in a mixture can be called the density of a component in a mixture.
In thermodynamics, the Volume Correction Factor (VCF), also known as Correction for the effect of Temperature on Liquid (CTL), is a standardized computed factor used to correct for the thermal expansion of fluids, primarily, liquid hydrocarbons at various temperatures and densities. [1]
V = air or gas volume of the closed space or room in cubic feet, cubic metres or litres; Q = ventilation rate into or out of the room in cubic feet per minute, cubic metres per hour or litres per second; C initial = initial concentration of a vapor inside the room measured in ppm; C final = final reduced concentration of the vapor inside the ...
This improper name persists, especially in elementary textbooks. In biology, the unit "%" is sometimes (incorrectly) used to denote mass concentration, also called mass/volume percentage. A solution with 1 g of solute dissolved in a final volume of 100 mL of solution would be labeled as "1%" or "1% m/v" (mass/volume). This is incorrect because ...
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.