Search results
Results From The WOW.Com Content Network
A line drawing showing some basic concepts of speeds and feeds in the context of lathe work. The angular velocity of the workpiece (rev/min) is called the "spindle speed" by machinists. Its tangential linear equivalent at the workpiece surface (m/min or sfm) is called the "cutting speed", "surface speed", or simply the "speed" by machinists.
A reamer is a type of rotary cutting tool used in metalworking. Precision reamers are designed to enlarge the size of a previously formed hole by a small amount but with a high degree of accuracy to leave smooth sides. There are also non-precision reamers which are used for more basic enlargement of holes or for removing burrs.
A machinist calculator is a hand-held calculator programmed with built-in formulas making it easy and quick for machinists to establish speeds, feeds and time without guesswork or conversion charts. Formulas may include revolutions per minute (RPM), surface feet per minute (SFM), inches per minute (IPM), feed per tooth (FPT). A cut time (CT ...
Finishing operations are carried out at low feeds and depths – dinners of 0.0125–0.04 mm/rev (0.0005–0.0015 in/rev) and depths of 0.75–2.0 mm (0.030–0.075 in) are typical. [9] Cutting speeds are lower in roughing than in finishing. A cutting fluid is often applied to the machining operation to cool and lubricate the cutting tool ...
The speeds and feeds used are varied to suit a combination of variables. The speed at which the piece advances through the cutter is called feed rate , or just feed ; it is most often measured as distance per time (inches per minute [in/min or ipm] or millimeters per minute [mm/min]), although distance per revolution or per cutter tooth are ...
Reamers & countersinks, High-Speed Steel and Carbide; ... An early example was an information wall-chart, recorded in 1952. ... (speeds and feeds, metal removal rates ...
A chamber reamer, regardless of pilot design, will operate most efficiently at speed of 200 to 300 RPM, and feed rate just fast enough to avoid chatter. Chamber reamers are designed with flutes to collect and extract the cut material, however these flutes must be periodically cleaned (typically after every .2" of cutting).
It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall. If the value is larger than 1 it is called a trumpet. Depending on the material being cut, feed rate and other factors, a cutting tool with the optimum K factor should be used.