Ads
related to: dodge 440 engine block number identification
Search results
Results From The WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
1978–1979: 6DR5 2.5 L 6G73 - Used in the Chrysler Sebring, Dodge Avenger, Chrysler Cirrus, and Dodge Stratus; 3.0 L 6G72 - Used in the Plymouth Acclaim/Dodge Spirit and 1987–2000 Dodge Caravan/Plymouth Voyager, also Dodge Dynasty, Chrysler LeBaron, Chrysler TC, Chrysler New Yorker, Dodge Daytona, Dodge Stealth, Chrysler Sebring (Coupe), Dodge Stratus (Coupe), Dodge Shadow ES, and Plymouth ...
All other engine options remained the same, including the 360 2-bbl designated by a K in the fifth symbol in the vehicle identification number. Several performance rear-end ratios were available, including a 3.23 "Sure Grip" rear end. A four-speed transmission was an option except with the 440 engine.
During 1963 and 1964 model years, the Dodge 440 was the mid-range model. [5] It featured less chrome and a plainer interior than the top-trimed Polara. For the 1965 model year, the 440, along with the 330 and 880 were all replaced by the Polara, which was built on the new C Body with 121-inch (3,073 mm) wheelbase.
Only the Imperial's engine remained in production for the Dodge Trucks' [1] 2-ton Models F-40 & K-50, 3-ton models F-60 & K-70, 2 & 3-ton Special, buses from 1930 to 1934-35. To replace these two engines, a new and very large six cylinder was launched in late 1936 (331 cu. in.), which grew to 413 cu in and was las used in the C-3 Series ...
Intended to deal with the troubles created by the low-production 426, of which only about 9,000 were built from 1966 to 1972), [4] as well as the different architectures of the higher-volume 383 cu in (6.3 L) and 400 cu in (6.6 L) B and 440 cu in (7.2 L) RB V8s, the ball-stud hemi was to be suitable for high-volume manufacture at low cost while ...
A Perkins 354-cubic-inch six-cylinder diesel engine option was offered in the D series for 1962, but was dropped because of lackluster demand. [3] The first generation of the D series was manufactured in Warren, Michigan. They were given the Dodge and Fargo brands. The trucks were produced by the Dodge Division of the Chrysler Corporation.
The Coronet R/T was available as a two-door hardtop or convertible. The standard engine was Chrysler's largest, the 440 cu in (7.2 L) V8 producing 375 bhp and dubbed the Magnum. The only engine option was the 426-cid Hemi, now in its second year in "Street" trim and again rated at 425 bhp. It was a $908 option.