Ads
related to: tower screw anchorsvaluefastener.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Screw foundations first appeared in the 1800s as pile foundations for lighthouses, [3] and were extensively used for piers in harbours. Between the 1850s through 1890s, more than 100 screw-pile lighthouses were erected on the east coast of the United States using screw piles. Made originally from cast or wrought iron, they had limited bearing ...
This type consists of a rod with wide screw blades on the end and an eyelet on the other for the guy wire. It is screwed deep into the ground, at the same angle as the guy, by a truck-mounted drill machine. These are commonly used as guy anchors for utility poles since they are quick to install with a truck mounted hydraulic powered auger drive.
A wall plug (UK English) also known as an anchor (US) or "Rawlplug" (UK), is a fibre or plastic (originally wood) insert used to enable the attachment of a screw in a material that is porous or brittle, or that would otherwise not support the weight of the object attached with the screw. [1] [2] It is a type of anchor that can be used to allow ...
A tower is a self-supporting structure, possibly also placed on a rooftop, that accomplishes the same purpose of raising actual radiating antennas to a functional height. Since it does not require land area from which to anchor guy lines, towers are more commonly used in cities where land is in short supply. [a]
Partially guyed towers in which at least one basement of the guy anchors is on the ground are more rare. The placement of guy basements across a broader geometric base allows for a mast much taller than the free-standing basement tower, and the integration of tower and mast should be considered in all facets of construction and maintenance.
Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...