Ads
related to: overhead door keypad programming instructionssmartholidayshopping.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.
The Keypad is typically found inside the front door or any other access door. The keypad is used to alarm the system on departure and disarm the system on entry. The cabling required is typically 22/4 multi strand copper cable .
Remote controls send a digital code word to the receiver. If the receiver determines the codeword is acceptable, then the receiver will actuate the relay, unlock the door, or open the barrier. Simple remote control systems use a fixed code word; the code word that opens the gate today will also open the gate tomorrow.
A typical single-car garage roller door has a preloaded spring inside the rolling mechanism. The spring reduces the effort required to open the door. Oversized roller doors in commercial premises are not sprung (except in the US), and a manual pulley and chain system or a geared motor is used to raise and lower (roll up and roll down) the door.
A male D-subminiature connector used for an RS-232 serial port on an IBM PC compatible computer along with the serial port symbol. A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1]
Access control door wiring when using intelligent readers and IO module. The most common security risk of intrusion through an access control system is by simply following a legitimate user through a door, and this is referred to as tailgating. Often the legitimate user will hold the door for the intruder.