Search results
Results From The WOW.Com Content Network
The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.
The LM6000 provides 54,610 shp (40,720 kW) from either end of the low-pressure rotor system, which rotates at 3,600 rpm.This twin spool design with the low pressure turbine operating at 60 Hz, the dominant electrical frequency in North America, eliminates the need for a conventional power turbine.
The LM2500+ is an evolution of the LM2500, delivering up to 40,200 shp (30,000 kW) or 28.6 MW of electric energy when combined with an electrical generator. Two of such turbo-generators have been installed in the superstructure near the funnel of Queen Mary 2, the world's largest transatlantic ocean liner, for additional electric energy for the ...
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
Hot gas from the gas generator flows into the power turbine, which turns at about 30,000 rpm. It has one stage on the small engines and two stages on the medium and large ones. For turboprop use, this powers a two-stage planetary output reduction gearbox, which turns the propeller at a speed of 1,900 to 2,200 rpm.
Turboshaft - 80 hp (60 kW) at 56,700 turbine rpm T62T-27 Turboshaft - 150 hp (110 kW) at 61,250 turbine rpm, with 1x 8,000 and 1x 8,216 rpm outputs. [1] T62T-29 Turboshaft - 95 hp (71 kW) at 56,700 turbine rpm, for Lockheed Jetstar and Pan American Falcon business Jets at 56,700 turbine rpm, with 1x 8,000 and 1x 8,100 rpm outputs. [1] T62T-32A
The turbine housings direct the gas flow through the turbine section, and the turbine itself can spin at speeds of up to 250,000 rpm. [28] [29] Some turbocharger designs are available with multiple turbine housing options, allowing a housing to be selected to best suit the engine's characteristics and the performance requirements.
Engine output peaks at 1,500 hp (1,100 kW), with 2,750 lb⋅ft (3,730 N⋅m) of torque at that peak, [2] which occurs at 3,000 rpm. [3] The turbine can provide torque in excess of 667 lb⋅ft (904 N⋅m) at significantly lower RPMs.