Ad
related to: 150mm flange dimensions standard
Search results
Results From The WOW.Com Content Network
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Standard sizes are indicated by the nominal inner diameter in millimeters for flanges 10 through 50 mm in diameter. [2] Sizes 10, 20 and 32 are less common sizes (see Renard numbers). Some sizes share their flange dimensions with their respective larger neighbor and use the same clamp size.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The size and shape for flanges on alpine skiing boots is standardized in ISO 5355. Traditional telemark and cross country boots use the 75 mm Nordic Norm, but the toe flange is informally known as the "duckbill". New cross country bindings eliminate the flange entirely and use a steel bar embedded within the sole instead.
In the US, flanges are either threaded or welded onto the pipe. In the European market flanges are usually welded onto the pipe. In the US, flanges are available in a standard 125 lb bolt pattern as well as a 250 lb (and heavier) bolt pattern (steel bolt pattern). Both are usually rated at 250 psi (1,700 kPa).
For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m). Wide flange section beams often vary from their nominal depth. In the case of the W14 series, they may be as deep as 22.84 in (580 mm).
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
A UG-1666/U (MIL-standard) choke flange (left), and matching gasket/cover flange (right). These flanges are aluminium and are socket-mounted onto aluminium WG18 (WR62) waveguide. Electric current flows on the inside surface of the waveguides, and must cross the join between them if microwave power is to pass through the connection without ...