Search results
Results From The WOW.Com Content Network
In Windows, the user can use the tool like ATATool to create a DCO. The user can set DCO to 100GB on hard drive 1: ATATOOL /SETDCO:100GB \\.\PhysicalDrive1 The user can remove DCO of 100GB on hard drive 1: ATATOOL /RESTOREDCO:100GB \\.\PhysicalDrive1 These commands can cause data loss or worse if they exeute this command that contains data. [6]
Setting non-AHCI mode (i.e. IDE or Combined mode) in the BIOS will allow the user to boot into Windows, and thereby the required registry change can be performed. Consequently, the user then has the option of continuing to use the system in Combined mode or switching to AHCI mode. [8]
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.
When booting in a true UEFI environment the Option ROM is not used as a SataDriver with the RST version takes over. In BIOS mode the legacy/BIOS booting is under CSMCORE. In true UEFI mode the RST is controlled under SataDriver / RstVmdDriver in BIOS. The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array.
Seagate provides a openSeaChest utility to allow you to interrogate and change many firmware settings including TLER. If you cannot use smartctl -l scterr,x,y to set the TLER, the relevant command-line commands are openSeaChest_Configure -d /dev/sg0 --sctReadTimer and openSeaChest_Configure -d /dev/sg0 --sctWriteTimer .