When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Device configuration overlay - Wikipedia

    en.wikipedia.org/wiki/Device_configuration_overlay

    Device configuration overlay (DCO) is a hidden area on many of today's hard disk drives (HDDs). Usually when information is stored in either the DCO or host protected area (HPA), it is not accessible by the BIOS (or UEFI), OS, or the user.

  3. Advanced Host Controller Interface - Wikipedia

    en.wikipedia.org/wiki/Advanced_Host_Controller...

    Setting non-AHCI mode (i.e. IDE or Combined mode) in the BIOS will allow the user to boot into Windows, and thereby the required registry change can be performed. Consequently, the user then has the option of continuing to use the system in Combined mode or switching to AHCI mode. [ 8 ]

  4. Hard disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Hard_disk_drive_interface

    The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.

  5. Error recovery control - Wikipedia

    en.wikipedia.org/wiki/Error_recovery_control

    Seagate provides a openSeaChest utility to allow you to interrogate and change many firmware settings including TLER. If you cannot use smartctl -l scterr,x,y to set the TLER, the relevant command-line commands are openSeaChest_Configure -d /dev/sg0 --sctReadTimer and openSeaChest_Configure -d /dev/sg0 --sctWriteTimer .

  6. Advanced Power Management - Wikipedia

    en.wikipedia.org/wiki/Advanced_Power_Management

    APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.

  7. Aggressive Link Power Management - Wikipedia

    en.wikipedia.org/wiki/Aggressive_Link_Power...

    When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.

  8. ‘A truly good man’: Trump, Obama, Bush and Clinton pay ...

    www.aol.com/truly-good-man-trump-obama-004714602...

    Barack Obama. Obama, the nation's 44th president, praised Carter's "decency" while leading the country and after he left the White House. "Elected in the shadow of Watergate, Jimmy Carter promised ...

  9. Self-Monitoring, Analysis and Reporting Technology - Wikipedia

    en.wikipedia.org/wiki/Self-Monitoring,_Analysis...

    With so many ways to connect a hard drive (SCSI, Fibre Channel, ATA, SATA, SAS, SSA, NVMe and so on), it is difficult to predict whether S.M.A.R.T. reports will function correctly in a given system. Even with a hard drive and interface that implements the specification, the computer's operating system may not see the S.M.A.R.T. information ...