Ads
related to: ezgo front suspension replacement videos
Search results
Results From The WOW.Com Content Network
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured the TTB axle for Ford.
A value of 50% would mean, that half of the weight transfer to the front wheels; during braking, it is being transmitted through front suspension linkage, and half is being transmitted through front suspension springs. For inboard brakes, the same procedure is followed, but using the wheel center instead of contact patch center.
A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
Conventional telescopic forks invariably have a pair of fork tubes, or "stanchions", at the top, clamped to a triple tree (also called a triple clamp or a yoke), and the sliders are at the bottom, attached to the front wheel spindle. Inside most tubes are springs, fork oil, and air, creating a shock absorber. Some forks allow pressurized air to ...
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...