When.com Web Search

  1. Ads

    related to: shure sm7b frequency response

Search results

  1. Results From The WOW.Com Content Network
  2. Shure SM7 - Wikipedia

    en.wikipedia.org/wiki/Shure_SM7

    Shure SM7B microphone used in an interview with Marius Bear. The Shure SM7 is a professional cardioid dynamic microphone, ... The wide frequency response of the SM7, ...

  3. Shure - Wikipedia

    en.wikipedia.org/wiki/Shure

    Shure Inc. is an audio products corporation headquartered in the USA. It was founded by Sidney N. Shure in Chicago, Illinois, in 1925 as a supplier of radio parts kits. The company became a manufacturer of consumer and professional audio-electronics including microphones, wireless microphone systems, phonograph cartridges, discussion systems, mixers, and digital signal processing.

  4. Shure SM58 - Wikipedia

    en.wikipedia.org/wiki/Shure_SM58

    The Shure SM58 is a professional cardioid dynamic microphone, commonly used in live vocal applications. ... Frequency response 50 to 15,000 Hz [9] Polar pattern

  5. Proximity effect (audio) - Wikipedia

    en.wikipedia.org/wiki/Proximity_effect_(audio)

    The proximity effect in audio is an increase in bass or low frequency response when a sound source is close to a directional or cardioid microphone. [1] [2] Proximity effect is a change in the frequency response of a directional pattern microphone that results in an emphasis on lower frequencies. It is caused by the use of ports to create ...

  6. Electro-Voice RE20 - Wikipedia

    en.wikipedia.org/wiki/Electro-Voice_RE20

    Frequency response 45 to 18,000 Hz Polar pattern Cardioid Sensitivity (at 1,000 Hz Open Circuit Voltage) 1.5 mV/Pascal Impedance 150 ohms Polarity Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 Connector Three-pin male XLR Switches Mid-bass reduction tone-shaping filter Net weight 737 grams (26.0 oz) [22]

  7. Loudspeaker measurement - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker_measurement

    Frequency response measurements are only meaningful if shown as a graph, or specified in terms of ±3 dB limits (or other limits). A weakness of most quoted figures is a failure to state the maximum SPL available, especially at low frequencies.