Ad
related to: 24mm xl gearbox ratcheting specs for sale today
Search results
Results From The WOW.Com Content Network
The transaxle configuration combines the gearbox and final drive in one housing and is only built in individual cases; In the transverse direction, the gearbox and final drive are very often combined in one housing due to the much more restricted space available; Every type of transmission occurs in every type of installation.
General Motors provided a fix for "Noise #1" but stated that "Noise #2" was a characteristic of any car equipped with a manual transmission and that a similar noise could be repeated by lugging the engine. The remedy for "Noise #1" was to overfill the transmission with Saturn Manual Transmission Lubricant from the stock 1.8 quarts to 2.6 quarts.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
The wide gear span [d] allows the engine speed level to be lowered (downspeeding), which is a decisive factor in improving energy efficiency and thus reducing fuel consumption. In addition, the lower engine speed level improves the noise-vibration-harshness comfort and the exterior noise is reduced by up to 4 dB(A). [ 1 ]
The letter F stands for "F"ront-wheel-drive. Although the F28 is only used in 4WD applications, the base transmission still remains a common FWD gearbox. The number 28 stands for the maximum torque capacity in Nm/10. 28 means that, the transmission is capable of transferring 280 N⋅m (210 lb⋅ft) nominal torque to the input shaft.
The ratio for 3rd gear is now 1.37:1, and the ratio for 4th gear is no longer an overdrive, with a new ratio of 1.05:1. The 5th gear ratio is 0.85:1 and the 6th gear ratio is 0.71:1. The addition of a ball-and-spring-type detent on the shift sleeve and detents on the shift rail assists the driver in shifting quicker.
The American Gear Manufacturers Association (AGMA) is the trade group of companies involved in gears, couplings and related power transmission components and equipment. AGMA was founded in 1916; as of December 30, 2016, there were 456 member companies listed on the association's website .