Ads
related to: adjustable ball swivel joints for chairs home depot
Search results
Results From The WOW.Com Content Network
U.S. Patent No 8771 drawing image Patent 8771 image close-up of parts Shaker ladder chair with ball swivels on rear legs for tilting. The Shaker tilting chair – named for its ball bearing or ball and socket [A] button mechanism assembled to the back two legs of a wooden chair – allowed a person to lean back in the chair without slipping or scraping the floor.
A rod end bearing, also known as a heim joint (North America) or rose joint (UK and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect alignment between the components ...
Adjustable three-point ball on lift arm. Ball may be rotated to fit either Category I or Category II implements Rear three-point hitch of a Case IH tractor with implement attached by the drawbar. There are five different hitch sizes, called categories. The higher category hitches have sturdier lift arms and larger connector pins. [2]
A swivel joint for a pipe is often a threaded connection in between which at least one of the pipes is curved, often at an angle of 45 or 90 degrees. The connection is tightened enough to be water- or air-tight and then tightened further so that it is in the correct position.
A swivel, swivelling, spinny, or revolving chair is a chair with a single central leg that allows the seat to rotate 360 degrees to the left or right. A concept of a rotating chair with swivel castors was illustrated by the Nuremberg noble Martin Löffelholz von Kolberg in his 1505 technological illuminated manuscript , the so-called Codex ...
A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...