Search results
Results From The WOW.Com Content Network
Twin BNC (also known as twinax) connectors use the same bayonet latching shell as an ordinary BNC connector but contain two independent contact points (one male and one female), allowing the connection of a 78 ohm or 95 ohm shielded differential pair such as RG-108A. [17]
EAD cables were duplex connections replacing two thin-wire cables, with the T-connector integrated into the BNC end. The contacts of an EAD outlet are closed if no connector is plugged in. When a cable is plugged in, the normally-closed contacts in the socket are opened so that signals pass through the loop cable.
This AUI cable could be up to 50 metres (160 ft) long, but was typically much shorter. With later standards, thicknet vampire taps and N connectors gave way to BNC connectors (for thinnet coax cables) and 8P8C connectors (for twisted-pair cables). MAUs for these were still connected to NICs via AUI cables, but soon the MAU ceased to be a ...
Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...
SR connector (from Russian: Cоединитель Pадиочастотный) is a Russian RF connector, based on the BNC connector and which comes in a 50 Ω and 75 Ω versions; TNC connector (threaded Neill-Concelman) Twin-BNC (Twinax) Twinax connectors are used with 78 Ω or 95 Ω conductor cables and operate from 0–200 MHz. Due to ...
10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.
For 10BASE5, connection to the coaxial cable was made with either a vampire tap or a pair of N connectors. For 10BASE2, the connection to the coaxial cable was typically made with a single BNC connector to which a T-piece was attached. For twisted-pair cabling 8P8C, modular connectors are used (often called RJ45 in this context).
XLR3 cable connectors, female on left and male on right. XLR connector plugs and sockets are used mostly in professional audio and video electronics cabling applications. XLR connector are also known as Cannon plugs after their original manufacturer. They are used for analog or digital balanced audio with a balanced line