Search results
Results From The WOW.Com Content Network
Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm An historic size for ships, also used for rockets and spacecraft. 15 mm figure scale for wargaming is considered interchangeable with this scale. [9] 1:100: 3.048 mm
For example, one inch measured from a drawing with a scale of "one-inch-to-the-foot" is equivalent to one foot in the real world (a scale of 1:12)....one inch measured from a drawing with a scale of "two-inches-to-the-foot" is equivalent to six inches in the real world (a scale of 1:6). It is not to be confused with a true unitless ratio.
6.5 mm (0.256 in) N: 1:150 1:160: 9 mm (0.354 in) The most popular scale in Japan. For models of Shinkansen high speed trains and other systems using standard gauge track, the international N scale standard ratio of 1:160 is commonly used. TT9: 1:120: 9 mm (0.354 in) Used also in New Zealand. HOn 2 + 1 ⁄ 2: 1:87: 9 mm (0.354 in)
The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale. Thus on an architect's drawing one might read 'one centimeter to one meter', 1:100, 1/100, or โ 1 / 100 โ . A bar scale would also normally appear on the drawing.
[8] [9] This scale is also used to depict 3 ft 6 in (1,067 mm) narrow-gauge railways (using N scale 9 mm / 0.354 in gauge track and known as NZ120) of New Zealand. N scale: 1:148: 9 mm As with 1:160 N scale below, the name is derived from its Nine millimeter track gauge, but the scale is a slightly larger at 2.0625 mm = 1 foot (1:147.78 ...
Depending upon the manufacturer (or country), the scale ranges from 1:148 to 1:160. Effectively the scale is 1:159, 9 mm to 1,435 mm (4 ft 8 + 1 ⁄ 2 in), which is the width of standard gauge railway. However the scale may vary to simulate wide or narrow-gauge rail. In all cases, the gauge (the distance between the rails) is 9 mm or 0.354 in.
Figures of 15 mm, 20 mm, 25 mm, 28 mm, 30 mm, 32 mm, and 35 mm are the most common for role-playing and table-top games. Smaller figures of 2 mm, 6 mm, 10 mm, 15 mm, and 20 mm are used for mass-combat wargames. Large sizes such as 40 mm and 54 mm were popular with wargamers in the past and are still used by painters and collectors.
Ratio Metric equivalent Sumerian Akkadian Cuneiform grain 1/180 2.8 mm še uลฃลฃatu ๐บ finger 1/30: 17 mm šu-si ubฤnu ๐ ๐ foot: 2/3: 331 mm šu-du 3-a šฤซzu ๐ ๐ ๐ cubit: 1: 497 mm kuš 3 ammatu ๐