Search results
Results From The WOW.Com Content Network
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
Peak normalization adjusts the recording based on the highest signal level present in the recording. Loudness normalization adjusts the recording based on perceived loudness . Normalization differs from dynamic range compression , which applies varying levels of gain over a recording to fit the level within a minimum and maximum range.
The P3b is a positive-going amplitude (usually relative to a reference behind the ear or the average of two such references) peaking at around 300 ms, though the peak will vary in latency (delay between stimulus and response) from 250 to 500 ms or later depending upon the task [2] and on the individual subject response. [1]
The commonly given measurement of PMPO (peak music power out) is largely meaningless and often used in marketing literature; in the late 1960s there was much controversy over this point and the US Government (FTA) required that RMS figures be quoted for all high fidelity equipment. Music power has been making a comeback in recent years.
A signal at +4 dBu is equivalent to a sine wave signal with a peak amplitude of approximately 1.736 volts, or any general signal at approximately 1.228 V RMS. Peak-to-peak (sometimes abbreviated as p-p ) amplitude (V PP ) refers to the total voltage swing of a signal, which is double the peak amplitude of the signal.
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts.The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated (with the rest of the electrical power being converted to heat).
Sonority is loosely defined as the loudness of speech sounds relative to other sounds of the same pitch, length and stress, [1] therefore sonority is often related to rankings for phones to their amplitude. [2] For example, pronouncing the vowel [a] will produce a louder sound than the stop [t], so [a] would rank higher in the hierarchy.
[1] [2] In acoustics, a formant is usually defined as a broad peak, or local maximum, in the spectrum. [3] [4] For harmonic sounds, with this definition, the formant frequency is sometimes taken as that of the harmonic that is most augmented by a resonance. The difference between these two definitions resides in whether "formants" characterise ...