Search results
Results From The WOW.Com Content Network
In telecommunications and electrical engineering in general, an unbalanced line is a pair of conductors intended to carry electrical signals, which have unequal impedances along their lengths and to ground and other circuits. Examples of unbalanced lines are coaxial cable or the historic earth return system invented for the telegraph, but ...
However, connecting an unbalanced circuit to, for instance, a twisted pair line, which is an intrinsically balanced format, makes the line susceptible to common-mode interference. [citation needed] For this reason, balanced lines are normally driven from balanced circuits. One option is to redesign the circuit so that it is properly impedance ...
A transition from a balanced to an unbalanced line requires a balun circuit. An example of this is CPW to slotline. Example D in the diagram shows this kind of transition and features a balun consisting of a dielectric radial stub. The component shown thus in this circuit is an air bridge bonding the two CPW ground planes together.
These three components complete a full circuit for a signal to travel through and the impedances of this circuit is what determines whether the interface as a whole is balanced or not: [3] "A balanced circuit is a two-conductor circuit in which both conductors and all circuits connected to them have the same impedance to ground and to all other ...
For example, transformation of 300-Ω twin-lead or 450-Ω ladder line (balanced) to 75-Ω coaxial cable (unbalanced), or to directly connect a balanced antenna to unbalanced coaxial cable. To avoid feed line radiation, baluns are typically used as a form of common mode choke attached at the antenna feed point to prevent the coaxial cable from ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
For example, in order to match an inductive load into a real impedance, a capacitor needs to be used. If the load impedance becomes capacitive, the matching element must be replaced by an inductor. In many cases, there is a need to use the same circuit to match a broad range of load impedance and thus simplify the circuit design.
A balanced circuit will normally show a symmetry of its components about a horizontal line midway between the two conductors (example in figure 3). This is different from what is normally meant by a symmetrical circuit, which is a circuit showing symmetry of its components about a vertical line at its midpoint. An example of a symmetrical ...