Search results
Results From The WOW.Com Content Network
Staggered wheel fitment usually appears on rear-wheel drive vehicles (and in smaller numbers some all wheel drive cars), when the rear wheels are wider than the front wheels. [11] Such a wheel setup may be found on the Ford Mustang, Infiniti G35, certain models of Mercedes and BMW, etc. A good example of such wheel combination is having 19 in ...
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
This transmission, like the Type 9, is already used in uprated classic cars and hot rods, especially if a Ford Pinto engine, a multi valve 4-cylinder or Rover V8 engine is used. It should not be confused with the MTX-75 which is a completely different gearbox for front wheel drive models such as the Mondeo , Ford Escort (Europe) also latterly ...
Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck applications. Also found in wide and narrow ratio configurations. Muncie SM319 transmission — 3-speed transmission physically identical to the Muncie SM318, with an added Borg Warner overdrive unit.
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...
R4 layout, the engine is located behind the rear axle. In automotive design, an R4, or rear-engine, four-wheel-drive layout places the engine at the rear of the vehicle, and drives all four roadwheels. This layout is typically chosen to improve the traction or the handling of existing vehicle designs using the rear-engine, rear-wheel-drive ...
These years actually featured a rear-mounted transmission, which was a stand-alone unit bolted directly to the differential. While many, including General Motors, refer to this configuration as a transaxle, the first Corvette with an integrated transaxle was produced in the eighth generation Corvette, which was released in the 2020 model year.
This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars. In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications. Beginning in 1998 a new 300mm torque converter with improved higher-capacity ...