When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Vacuum casting (elastomers) - Wikipedia

   en.wikipedia.org/wiki/Vacuum_casting_(elastomers)

   The process starts by placing a two piece silicone mold in a vacuum chamber. The raw material is mixed, degassed and then poured into the mold. The vacuum is then released and the mold removed from the chamber. Finally, the casting is cured in an oven and the mold removed to release the completed casting. The silicone mold can be reused. [3]

3. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The matrix is created by the other ingredients in the semi-permanent mold release. Applications of semi-permanent mold release vary from every cycle to once daily applications depending on the compound being molded and the design and quality of the mold. Silicone-based rubber products, however, require a non-silicone based releasing agent.

4. Injection molding of liquid silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Injection_molding_of...

   Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.

5. Compression molding - Wikipedia

   en.wikipedia.org/wiki/Compression_molding

   Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

6. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Silicone mold used to reproduce an architectural detail. Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone.

7. Silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Silicone_rubber

   In its uncured state, silicone rubber is a highly adhesive gel or liquid. To convert it to a solid, it must be cured, vulcanized, or catalyzed.This is normally carried out in a two-stage process at the point of manufacture into the desired shape, and then in a prolonged post-cure process.