Ads
related to: homemade generator is better than standard size furnace part 2thomasnet.com has been visited by 100K+ users in the past month
smartholidayshopping.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
They comprise a compressor, combustor, impeller/turbine and electric generator on a single shaft or two. They can have a recuperator capturing waste heat to improve the compressor efficiency, an intercooler and reheat. They rotate at over 40,000 RPM and a common single shaft microturbine rotate usually at 90,000 to 120,000 RPM. [2]
This project was an electric power plant with a wood gas generator and a gas engine to convert the wood gas into 2 MW electric power and 4.5 MW heat. There was also an experimental device to use the Fischer–Tropsch process to convert wood gas to a diesel-like fuel. By October 2005, it was possible to convert 5 kg of wood into 1 litre of fuel.
A boiler or steam generator is a device used to create steam by applying heat energy to water. Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low to medium pressure (7–2,000 kPa or 1–290 psi ) but, at pressures above this, it is more usual to speak of a ...
A steam generator is a form of low water-content boiler, similar to a flash steam boiler. The usual construction is as a spiral coil of water-tube , arranged as a single, or monotube , coil. Circulation is once-through and pumped under pressure, as a forced-circulation boiler . [ 1 ]
A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream, such as a combustion turbine or other waste gas stream. It produces steam that can be used in a process ( cogeneration ) or used to drive a steam turbine ( combined cycle ).
Philips MP1002CA Stirling generator of 1951. During the early part of the 20th century, the role of the Stirling engine as a "domestic motor" [32] was gradually taken over by electric motors and small internal combustion engines. By the late 1930s, it was largely forgotten, only produced for toys and a few small ventilating fans. [33]