Search results
Results From The WOW.Com Content Network
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...
Parts of a fillet weld. There are 5 pieces to each fillet weld known as the root, toe, face, leg and throat. [2] The root of the weld is the part of deepest penetration which is the opposite angle of the hypotenuse. The toes of the weld are essentially the edges or the points of the hypotenuse.
Weld mapping is the process of assigning information to a weld repair or joint to enable easy identification of weld processes, production (welders, their qualifications, date welded), quality (visual inspection, NDT, standards and specifications) and traceability (tracking weld joints and welded castings, the origin of weld materials).
Structural welding (sheet steel) AWS D1.4: Structural welding (reinforcing steel) AWS D1.5: Bridge welding AWS D1.6: Structural welding (stainless steel) AWS D1.7: Structural welding (strengthening and repair) AWS D1.8: Structural welding seismic supplement AWS D1.9: Structural welding (titanium) AWS D3.6R: Underwater welding (Offshore & inland ...
During the welding process, residual stresses can present themselves in the area of the weld, either in the heat affected zone or fusion zone. The mean stress a welded joint may see in application, can be altered due to the welding processes implementing residual stresses, changing the fatigue life and can render S-N laboratory testing results ...
This is a list of welding processes, separated into their respective categories. The associated N reference numbers (second column) are specified in ISO 4063 (in the European Union published as EN ISO 4063 ). [ 1 ]
Butt welding is performed with the Arc, TIG, or MIG welder held at a slight angle the weld if the weld is laying flat in order to achieve the least amount of porosity in the weld and also to increase the weld's strength. [1] Fillet welding make up about 80 percent of the connection despite being weaker than butt welds. [1]
Undercutting is when the weld reduces the base metal's cross-sectional thickness and reduces the strength of the weld and workpieces. One reason for this type of defect is excessive current, which causes the edges of the joint to melt and drain into the weld, thus leaving a drain-like impression along the length of the weld.