Search results
Results From The WOW.Com Content Network
The test reports loss of mass to abrasion and impact, expressed as a percentage of initial sample mass. [7] Maximum acceptable loss for the base course of the road is 45%; the more demanding surface course must be 35% or less. [1] The test was developed by the city engineers of Los Angeles in the 1920s. [8]
Basic sediment and water (BS&W) is both a technical specification of certain impurities in crude oil and the method for measuring it. When extracted from an oil reservoir, the crude oil will contain some amount of water and suspended solids from the reservoir formation. The particulate matter is known as sediment or mud.
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.
ASTM International, formerly known as American Society for Testing and Materials, is a standards organization that develops and publishes voluntary consensus technical international standards for a wide range of materials, products, systems and services. Some 12,575 apply globally.
The liquid limit test is defined by ASTM standard test method D 4318. [4] The test method also allows running the test at one moisture content where 20 to 30 blows are required to close the groove; then a correction factor is applied to obtain the liquid limit from the moisture content. [5]
Pendulum floor slip resistance tester. The ASTM E303-22 [1] (United States), BS EN 16165:2021, [2] BS EN 13036-4:2011 [3] (United Kingdom and many other European nations), AS 4663:2013 - Slip resistance of existing pedestrian surfaces, and AS 4586:2013 - Slip resistance classification of new pedestrian surface materials (Australia/New Zealand) slip resistance test standards define the pendulum ...
For premium support please call: 800-290-4726
The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed worldwide. The test procedure is described in ISO 22476-3, ASTM D1586 [1] and Australian Standards AS ...