When.com Web Search

  1. Ads

    related to: metal punch for jewelry making machine tools and accessories set

Search results

  1. Results From The WOW.Com Content Network
  2. Turret punch - Wikipedia

    en.wikipedia.org/wiki/Turret_punch

    A turret punch or turret press is a type of punch press used for metal forming by punching. Punching, and press work in general, is a process well suited to mass production. However the initial tooling costs, of both the machine and the job-specific press tool, are high. This limits punch work from being used for much small-volume and prototype ...

  3. Punch press - Wikipedia

    en.wikipedia.org/wiki/Punch_press

    Quick change tool system (left: die; front: punch, split punch retainer; back: tool body; right: punch guide) A die set consists of a set of punches and dies which, when pressed together, form a hole in a workpiece (and may also deform the workpiece in some desired manner). The punches and dies are removable, with the punch being attached to ...

  4. Types of press tools - Wikipedia

    en.wikipedia.org/wiki/Types_of_press_tools

    The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.

  5. Punch (tool) - Wikipedia

    en.wikipedia.org/wiki/Punch_(tool)

    A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

  6. Category:Metalworking tools - Wikipedia

    en.wikipedia.org/wiki/Category:Metalworking_tools

    Machine tools (4 C, 51 P) Metalworking cutting tools ... Pages in category "Metalworking tools" ... Turret punch; U. Unimat; W.

  7. Blanking and piercing - Wikipedia

    en.wikipedia.org/wiki/Blanking_and_piercing

    This allows for complex shapes to be formed in sheet metal up to 6 mm (0.25 in) thick using simple tools. [4] that is essentially a small punch and die that reciprocates quickly; around 300–900 times per minute. Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow ...