When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. CDP spoofing - Wikipedia

    en.wikipedia.org/wiki/CDP_spoofing

    CDP is enabled by default on all Cisco routers, switches and servers. The protocol can be disabled across a network; however, if it is disabled on an interface and the encapsulation is changed, it will be re-enabled on that interface. [5] [6] The protocol is most often used to aid network administrators by finding and discovering devices easier ...

  3. VLAN Trunking Protocol - Wikipedia

    en.wikipedia.org/wiki/VLAN_Trunking_Protocol

    A VTP domain for a network is a set of all contiguously trunked switches with the matching VTP settings (domain name, password and VTP version). All switches in the same VTP domain share their VLAN information with each other, and a switch can participate in only one VTP management domain. Switches in different domains do not share VTP information.

  4. Default gateway - Wikipedia

    en.wikipedia.org/wiki/Default_gateway

    The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.

  5. Default route - Wikipedia

    en.wikipedia.org/wiki/Default_route

    The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...

  6. Cisco IOS - Wikipedia

    en.wikipedia.org/wiki/Cisco_IOS

    Most Cisco products that run IOS also have one or more "feature sets" or "packages", typically eight packages for Cisco routers and five packages for Cisco network switches. For example, Cisco IOS releases meant for use on Catalyst switches are available as "standard" versions (providing only basic IP routing), "enhanced" versions, which ...

  7. Point-to-Point Protocol - Wikipedia

    en.wikipedia.org/wiki/Point-to-Point_Protocol

    PPP can assign IP addresses to these virtual interfaces, and these IP addresses can be used, for example, to route between the networks on both sides of the tunnel. IPsec in tunneling mode does not create virtual physical interfaces at the end of the tunnel, since the tunnel is handled directly by the TCP/IP stack.

  8. Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.

  9. route (command) - Wikipedia

    en.wikipedia.org/wiki/Route_(command)

    -n: Bypasses translating IP addresses to symbolic host names-q: Suppresses all output-v: Verbose; COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination