Ad
related to: what is a sata ahci driver windows 7
Search results
Results From The WOW.Com Content Network
Some operating systems, notably Windows Vista, Windows 7, Windows 8, Windows 8.1 and Windows 10, do not configure themselves to load the AHCI driver upon boot if the SATA controller was not in AHCI mode at the time the operating system was installed. Although this is an easily rectifiable condition, it remains an ongoing issue with the AHCI ...
Both modes work with SATA drives. The boot mode choice, with one mode or the other, is chosen in modern BIOS/UEFI after driver installation. [3] Once one or the other driver is installed, it is not possible for the Windows operating system to boot again with the BIOS/UEFI set to RAID/IDE, producing BSOD in case of trying. [4]
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
For a short time in March 2010, users were led to believe that the Intel Rapid Storage Technology (RST) 9.6 (and later) drivers in Windows 7 supported TRIM on RAID volumes, but Intel later clarified that TRIM was supported for the BIOS settings of AHCI mode and RAID mode, but not if the drive was part of a RAID volume.
The appropriate driver must be loaded into the operating system to enable NCQ on the host bus adapter. [3] Many newer chipsets support the Advanced Host Controller Interface (AHCI), which allows operating systems to universally control them and enable NCQ. DragonFly BSD has supported AHCI with NCQ since 2.3 in 2009.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
This restriction applies only to 32-bit Windows XP; 64-bit Windows XP is supported by Intel drivers. For motherboards with X79 chipset but with third party SATA disk controllers, 32-bit Windows XP AHCI drivers may still be supported by the disk controller vendor (non-Intel). A third party, generic Intel AHCI/RAID driver for 32-bit Windows XP ...
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.