Ad
related to: what is a 4 bolt main engine
Search results
Results From The WOW.Com Content Network
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
There were a few different versions of the LT1. All feature a cast iron block, with aluminum heads in the Y- and F-bodies, and cast iron heads in the B- and D-bodies. Corvette blocks had four-bolt main caps, while most other blocks were two-bolt main caps. Block castings remained the same between 2 and 4 bolt mains.
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
It had 2-bolt main bearing caps in 1969, but went to a block similar to the Ram Air IV's in 1969 that was drilled for 4-bolt main bearing caps (but used a cast crank and cast rods). In 1970 the casting number #9799914 Ram Air 400 4-bolt main block also used the 4-bolt main caps on Ram Air applications.
4.0L was produced by Ford Cologne Germany (like the unrelated and the all-new metric Taurus/Sable FWD 3.0 V6). Both were put in the North American Ranger, Aerostar, Explorer platforms. The 4.0L bellhousing and the 3.0L bellhousings "MAY" interchange, but they do not interchange with the previous Cologne engines.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
All 4.6 L 4-valve engines featured aluminum engine blocks with 6-bolt main bearing caps, the only exception being the 2003–2004 SVT Cobra which had a 4-bolt main cast iron block. The 1999 and earlier engines featured an aluminum block cast in Italy by Fiat subsidiary Teksid S.p.A. Since 1996, all of the 4.6 L 4-valve engines manufactured for ...
A semi-closed deck structure, an integrated ladder frame and four-bolt main bearing caps contribute to engine strength, durability, and lower NVH levels. Unlike the 4G63, the 4B11T does not use a balancer shaft. The semi-floating pistons of the 4G63 have been replaced with fully floating pistons for the 4B11T.