Search results
Results From The WOW.Com Content Network
An Icom IC-R5 hand-held scanner A GMRS radio that also has scanning capabilities. A scanner (also referred to as a radio scanner) is a radio receiver that can automatically tune, or scan, two or more discrete frequencies, stopping when it finds a signal on one of them and then continuing to scan other frequencies when the initial transmission ceases.
Because period is the inverse of frequency, lower tone frequencies can take longer to decode (depends on the decoder design). Receivers in a system using 67.0 Hz can take noticeably longer to decode than ones using 203.5 Hz, and they can take longer than one decoding 250.3 Hz. In some repeater systems, the time lag can be significant. The lower ...
Frequency sweeps may be used by regulatory agencies to monitor the radio spectrum, to ensure that users only transmit according to their licenses.The FCC for example controls and monitors the use of the spectrum in the U.S.
When the incoming radio signal is at the resonant frequency, the resonant circuit has high impedance and the radio signal from the desired station is passed on to the following stages of the receiver. At all other frequencies the resonant circuit has low impedance, so signals at these frequencies are conducted to ground.
Users should be aware that UHF CB channels 31 to 38 and 71 to 78 are the 'input' channels for repeaters. Users should avoid using these channels to avoid interfering with repeaters. If a repeater is to be used, switch to 1–8 or 41–48 and press the duplex button.
Radio frequency (RF) is the oscillation rate of an alternating electric current or voltage or of a magnetic, ...
Unlike a conventional radio which assigns users a certain frequency, a trunk system uses a number of frequencies allocated to the entire system. Then the control channel coordinates the system so talkgroups can share these frequencies seamlessly. The purpose is to dramatically increase system capacity with optimal use of frequencies.
Frequency range [1] 136–174 MHz 400–520 MHz: Frequency steps 2.5–50k Hz Transmitter power output: 5 W PEP: Waveforms (modulations) FM: modulation rate: Power input Receiver only 20 mA, Transmitter 1 A max. Operating voltage 6.5 – 9 V, Nominal voltage 7.2 V: Measurements and weight High 140 mm Width 70 mm Depth 30 mm Weight approx. 400 grams