Search results
Results From The WOW.Com Content Network
Later models came with hydraulic clutches. These were commonly found in Pintos, some Mustang II/Capris, and Rangers but do not match the V6 Bell housings. Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines.
Ford developed a supercharged version of the 3.8 L Essex V6 that was used in two Ford MN12 platform cars beginning in the late 1980s. A belt driven Eaton M90 roots-type supercharger spinning at 2.6 times engine rpm, to a maximum of 15,000 rpm at the engine's 6000 rpm redline, provided up to 12 psi (0.83 bar) of boost. [7]
The Mustang GT also featured a stiffer handling suspension, a 3.08:1 rear axle ratio (later changed to 3.27:1 or 3.55:1 depending on the transmission and model year), dual exhaust tips, and larger 16-inch (410 mm) wheels (compared to the base Mustang's 15-inch wheels). The 1994 Mustang GT was named Motor Trend Car of the Year.
The last production vehicle available with the Vulcan V6 was the 2008 Ford Ranger. Although it shared the Vulcan V6's general layout, 60° cylinder bank angle, bore, stroke, bore spacing, and a few minor components, the SHO V6 was an engine designed and built by Yamaha with new DOHC cylinder heads and a redesigned, strengthened engine block. [6]
The 250 cu in (4.1 L) inline-six engine was offered in 1969 in the Mustang, and 1970 in compact Ford cars (Maverick). The 250 was a stroked 200, made by increasing the stroke from 3.126 to 3.91 in (79.4 to 99.3 mm). Output was 155 hp (116 kW) in the Mustang, and the 250 became the base engine in 1971.
GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983). These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing.
The third-generation Mustang was manufactured and marketed by Ford from 1979–1993, using the company's Fox platform and colloquially called the Fox body Mustang.During its third generation, the Mustang evolved through several sub-models, trim levels, and drivetrain combinations during its production and seemed destined for replacement with a front-wheel drive Mazda platform.
The Cologne V6 was designed to be compatible in installation with the Ford Taunus V4 engine, having the same transmission bolt pattern, the same engine mounts, and in many versions, a cylinder head featuring "siamesed" exhaust passages, which reduced the three exhaust outlets down to two on each side. The latter feature was great for ...