Search results
Results From The WOW.Com Content Network
It is referred to as non-volatile memory or NVRAM because, after the system loses power, it does retain state by virtue of the CMOS battery. When the battery fails, BIOS settings are reset to their defaults. The battery can also be used to power a real time clock (RTC) and the RTC, NVRAM and battery may be integrated into a single component ...
In the case of a hard reboot, the northbridge will direct a code fetch request to the BIOS located on the system flash memory. For a warm boot, the BIOS will be located in the proper place in RAM and the northbridge will direct the reset vector call to the RAM. In earlier PC systems, before chipsets were standard, the BIOS ROM would be located ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
Older, less common BIOS-bootable devices include floppy disk drives, Zip drives, and LS-120 drives. Typically, the system firmware (UEFI or BIOS) will allow the user to configure a boot order. If the boot order is set to "first, the DVD drive; second, the hard disk drive", then the firmware will try to boot from the DVD drive, and if this fails ...
In computing, the System Management BIOS (SMBIOS) specification defines data structures (and access methods) that can be used to read management information produced by the BIOS of a computer. [1] This eliminates the need for the operating system to probe hardware directly to discover what devices are present in the computer.
Later the decreased cost of the CMOS technology allowed the same devices to be fabricated using it, adding the letter "C" to the device numbers (27xx(x) are n-MOS and 27Cxx(x) are CMOS). While parts of the same size from different manufacturers are compatible in read mode, different manufacturers added different and sometimes multiple ...
The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 (high voltage level) and reset to store a logic 0 (low voltage level). Its value is maintained/stored until it is changed by the set/reset process. The value in the memory cell can be accessed by reading it.
The detection of a RESET signal causes the processor to enter a system initialization period of six clock cycles, after which it sets the interrupt request disable flag in the status register and loads the program counter with the values stored at the processor initialization vector ($00FFFC – $00FFFD) before commencing execution. [1]