Search results
Results From The WOW.Com Content Network
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
504 Gateway Timeout The server was acting as a gateway or proxy and did not receive a timely response from the upstream server. 505 HTTP Version Not Supported The server does not support the HTTP version used in the request. 506 Variant Also Negotiates (RFC 2295) Transparent content negotiation for the request results in a circular reference. [27]
On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address and Default Gateway address.
If you're using broadband (cable) internet and you can't connect, try the following troubleshooting steps in the order listed until you get up and running again. 1. Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using.
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
ArmA multiplayer (default port for game +3) [169] 2351: Unofficial: AIM game LAN network port [citation needed] 2368: Unofficial: Ghost (blogging platform) [172] 2369: Unofficial: Default for BMC Control-M/Server Configuration Agent 2370: Unofficial: Default for BMC Control-M/Server, to allow the Control-M/Enterprise Manager to connect to the ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
In Windows XP, NAT traversal is enabled by default, but in Windows XP with Service Pack 2 it has been disabled by default for the case when the VPN server is also behind a NAT device, because of a rare and controversial security issue. [6] IPsec NAT-T patches are also available for Windows 2000, Windows NT and Windows 98. [citation needed]