When.com Web Search

  1. Ads

    related to: female to male antenna adapter

Search results

  1. Results From The WOW.Com Content Network
  2. TNC connector - Wikipedia

    en.wikipedia.org/wiki/TNC_connector

    The TNCA connector is a variant of the TNC connector specified in MIL-STD-348 [1] designed to provide an air gap in the dielectric region between the male and female connectors. The female TNCA connector is nearly identically to the standard TNC female connector, while the male TNCA connector provides the air cavity differentiating it from a ...

  3. BNC connector - Wikipedia

    en.wikipedia.org/wiki/BNC_connector

    Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...

  4. SMA connector - Wikipedia

    en.wikipedia.org/wiki/SMA_connector

    SMA connectors must not be confused with the standard household 75-ohm type F coax connector (diameters: male 7 ⁄ 16 inch (11 mm) circular or hex; female 3 ⁄ 8 inch (9.5 mm) external threads), as there is only about a 2 mm difference overall in the specifications. Type F cannot be mated with SMA connectors without the use of an adapter.

  5. FME connector - Wikipedia

    en.wikipedia.org/wiki/FME_connector

    The FME female is designed to be low diameter to allow cables it has been installed on to be snaked through the often tight access holes or spaces of a vehicle to the desired equipment location(s) where an FME male adapter to the required equipment connector series is fitted to the female cable connector. The thread is 8mm*0.75mm pitch, and the ...

  6. 7/16 DIN connector - Wikipedia

    en.wikipedia.org/wiki/7/16_DIN_connector

    The 7-16 DIN connector or 7/16 (seven and sixteen millimeter DIN) is a 50 Ω threaded RF connector used to join coaxial cables.It was designed to reduce passive intermodulation from multiple transmitters.

  7. F connector - Wikipedia

    en.wikipedia.org/wiki/F_connector

    The F connector is not weatherproof. Neither the threads nor the joint between male connector body and captive nut provide a water-tight seal. However, male connectors are commonly enhanced with an o-ring (of about 7 mm) inside the captive nut. This seals between the mating faces of both connectors, providing some protection for the center ...