Search results
Results From The WOW.Com Content Network
A p–n junction diode. The circuit symbol is also shown. A p–n junction is a combination of two types of semiconductor materials, p-type and n-type, in a single crystal. The "n" (negative) side contains freely-moving electrons, while the "p" (positive) side contains freely-moving electron holes.
Tunnel diodes and Gunn diodes are examples of components that have negative resistance. Hysteresis vs single-valued : Devices which have hysteresis ; that is, in which the current–voltage relation depends not only on the present applied input but also on the past history of inputs, have I–V curves consisting of families of closed loops.
This simple diode clamp will clamp the negative peaks of the incoming waveform to the common rail voltage. A diode clamp circuit can take a periodic alternating current signal that oscillates between positive and negative values, and vertically displace it such that either the positive or the negative peaks occur at a prescribed level. The ...
The figure shows a band bending diagram for a p–n diode; that is, the band edges for the conduction band (upper line) and the valence band (lower line) are shown as a function of position on both sides of the junction between the p-type material (left side) and the n-type material (right side).
For example, reversing the current direction in a Daniell galvanic cell converts it into an electrolytic cell [1] where the copper electrode is the positive terminal and also the anode. In a diode , the cathode is the negative terminal at the pointed end of the arrow symbol, where current flows out of the device.
English: a PN diode that display the electrical symbol associated with it. The triangle corresponds to the p side, while the other side is the n side The triangle corresponds to the p side, while the other side is the n side
A hand-made diode bridge. The silver band on the diodes indicates the cathode side of the diode.. A diode bridge is a bridge rectifier circuit of four diodes that is used in the process of converting alternating current (AC) from the input terminals to direct current (DC, i.e. fixed polarity) on the output terminals.
The PIN diode obeys the standard diode equation for low-frequency signals. At higher frequencies, the diode looks like an almost perfect (very linear, even for large signals) resistor. The P-I-N diode has a relatively large stored charge adrift in a thick intrinsic region. At a low-enough frequency, the stored charge can be fully swept and the ...