Ads
related to: ignition condenser test with multimeter
Search results
Results From The WOW.Com Content Network
The Delco ignition system, also known as the Kettering ignition system, points and condenser ignition or breaker point ignition, is a type of inductive discharge ignition system invented by Charles F. Kettering. It was first sold commercially on the 1912 Cadillac [1] and was manufactured by Delco.
Capacitor discharge ignition (CDI) or thyristor ignition is a type of automotive electronic ignition system which is widely used in outboard motors, motorcycles, lawn mowers, chainsaws, small engines, gas turbine-powered aircraft, and some cars.
The 14CUX is capable of storing diagnostic trouble codes in a 32-byte segment of its internal memory that is maintained (even while vehicle ignition is off) by applying 5VDC (regulated down from 12VDC from the vehicle's battery.) Because of this maintainer voltage, the ECU is always drawing a small amount of current.
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
Articles relating to ignition systems, which generate a spark or heat an electrode to a high temperature to ignite a fuel-air mixture. Subcategories This category has only the following subcategory.
As batteries became more common in cars (due to the increased usage of electric starter motors), magneto systems were replaced by systems using an induction coil.The 1886 Benz Patent-Motorwagen and the 1908 Ford Model T used a trembler coil ignition system, whereby the trembler interrupted the current through the coil and caused a rapid series of sparks during each firing.
These effects can largely be overcome using electronic ignition systems, where the contact breakers are retrofitted by a magnetic (Hall effect) or optical sensor device. However, because of their simplicity, and since contact breaker points gradually degrade instead of catastrophically failing, they are still used on aircraft engines.
This sensor is one of the two most important sensors in modern-day engines, together with the camshaft position sensor. As the fuel injection (diesel engines) or spark ignition (petrol engines) is usually timed from the crank sensor position signal, failing sensor will cause an engine not to start or will cut out while running.
Ad
related to: ignition condenser test with multimeter