Ad
related to: 45° din thread angle calculator
Search results
Results From The WOW.Com Content Network
Metric trapezoidal threads [1] Tr 30° DIN 103 Buttress threads [6] S 45° DIN 2781 German buttress threads [6] S 30° DIN 513 Square threads [1] Sq 0° (parallel) ? Panzergewinde, "steel conduit thread" Pg 80° DIN 40430 British Association (BA) thread: BA 47° 30' = 47.5° BS 93:2008 Löwenherz thread [8] 53° 8' ≈ 53.1° Bodmer thread [9] 50°
The included angle characteristic of the cross-sectional shape is often called the thread angle. For most V-threads, this is standardized as 60 degrees, but any angle can be used. The cross section to measure this angle lies on a plane which includes the axis of the cylinder or cone on which the thread is produced.
Knuckle threads with a flat 30 degree flank thread angle are standardized in DIN 405 for inch pitches and diameters ranging from 8 mm to 200 mm. [3] A more recent standard DIN 20400 uses metric thread pitch and lists diameters from 10 mm to 300 mm. [4] As DIN is a German organization, many instances of the DIN thread charts [5] write numbers with a comma as the decimal marker.
UTS threads do not usually use the pitch parameter; instead a parameter known as threads per inch (TPI) is used, which is the reciprocal of the pitch. The relationship between the height H and the pitch P is found using the following equation where θ is half the included angle of the thread, in this case 30°: [1]
The thread angle is the included angle, measured at a section parallel to the axis, between the two bearing faces of the thread. The angle between the axial load force and the normal to the bearing surface is approximately equal to half the thread angle, so the thread angle has a great effect on the friction and efficiency of a screw, as well ...
The Thury thread form had the crests rounded at 1 / 6 p and the roots rounded at 1 / 5 p so the thread angle was close to 47.5° but not exactly. This was simplified in the BA thread definition by defining the thread angle to be 47.5° exactly and the thread form to be symmetrical with a depth of 3 / 5 p.
The efficiency can be plotted versus the helix angle for a constant friction, as shown in the adjacent diagram. The maximum efficiency is a helix angle between 40 and 45 degrees, however a reasonable efficiency is achieved above 15°. Due to difficulties in forming the thread, helix angle greater than 30° are rarely used.
Each thread is characterized by its major diameter, D (D maj in the diagram), and its pitch, P. ISO metric threads consist of a symmetric V-shaped thread. In the plane of the thread axis, the flanks of the V have an angle of 60° to each other. The thread depth is 0.54125 × pitch.