Search results
Results From The WOW.Com Content Network
Most, but not all, instructions that use DS by default will accept an ES override prefix. Processor stack references, either implicitly (e.g. push and pop instructions) or explicitly (memory accesses using the (E)SP or (E)BP registers) use the stack segment specified by the segment selector held in the SS register.
A start-stop system off button on a Perodua Myvi. A vehicle start-stop system or stop-start system (also known as S&S, micro hybrid, or micro hybrid electric vehicle (μHEV)) [1] automatically shuts down and restarts the internal combustion engine to reduce the amount of time the engine spends idling, thereby reducing fuel consumption and emissions.
It was a fully static NMOS 8-bit microprocessor. The static nature was unusual for the time, and meant that the processor could be halted simply by stopping the clock signal. Programmers made grateful use of this feature to "single step' through a program using a push-button switch to generate the clock pulses.
A push-button ignition switch in place of the immobilizer on a Mitsubishi RVR equipped with the Smart key. Vehicles with a smart-key system can disengage the immobilizer and activate the ignition without inserting a key in the ignition, provided the driver has the key inside the car.
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
Extended RAM on models with more than 2048 bytes of RAM. (0x1100–0x18FF is a copy of 0x0200–0x09FF) 0x1100–0xFFFF Up to 60 kilobytes of program ROM. Smaller ROMs start at higher addresses. The last 16 or 32 bytes are interrupt vectors. A few models include more than 2048 bytes of RAM; in that case RAM begins at 0x1100.
One technique used on early IBM XT computers was to install additional RAM into the video memory address range and push the limit up to the start of the Monochrome Display Adapter (MDA). Sometimes software or a custom address decoder was required for this to work. This moved the barrier to 704 KB (with MDA/HGC) or 736 KB (with CGA). [6] [7]
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.