When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Fence (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Fence_(woodworking)

   [3] [4]: 121–125 The most common fence on a table saw is a rip fence, and is provided as standard with any new table saw. The rip fence is parallel to the saw blade and can be adjusted to different distances from the blade to set the size of the final cut. The fence remains static, while the workpiece is guided along the fence. [5]

3. Sabre (fencing) - Wikipedia

   en.wikipedia.org/wiki/Sabre_(fencing)

   "The blade, which must be of steel, is approximately rectangular in section. The maximum length of the blade is 88 cm (35 in). The minimum width of the blade, which must be at the button, is 4 mm (0.16 in); its thickness, also immediately below the button, must be at least 1.2 mm (0.047 in)." [3]: m.23.1

4. Épée - Wikipedia

   en.wikipedia.org/wiki/Épée

   Electric épée fencing: Diego Confalonieri (left) and Fabian Kauter in the final of the Trophée Monal While the modern sport of fencing has three weapons — foil, épée, and sabre, each a separate event — the épée is the only one in which the entire body is the valid target area (the others are restricted to varying areas above the waist).

5. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   These saws made it more efficient to cut small pieces such as lath. After 1813 or 1822 saw mills use large circular saws, up to 3 metres (9.8 ft) in diameter. Large saws demand more power than up-and-down saws and did not become practical for sawing timbers until they were powered by steam engines. They are either left or right-handed ...

6. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   The whole saw blade is made of High-Speed Steel (HSS). HSS saw blades are mainly used to cut steel, copper, aluminum and other metal materials. If high-strength steels (e.g., stainless steel) are to be cut, the blades made of cobalt HSS (e.g. M35, M42) should be used. Tungsten carbide Normally, there are two ways to use tungsten carbide to make ...

7. Two-man saw - Wikipedia

   en.wikipedia.org/wiki/Two-man_saw

   Felling saws were used to fell the trees, and bucking saws were used to cut felled trees into log lengths for the sawmill. [3] The two applications require slightly different designs: a felling saw has a narrower blade, allowing wedges to be more easily inserted, while a bucking saw has a wider blade, giving it more strength.