Ad
related to: does a dipole need balun water to reach one touch screen
Search results
Results From The WOW.Com Content Network
For a gain measured relative to a dipole, one says the antenna has a gain of " x dBd" (see Decibel). More often, gains are expressed relative to an isotropic radiator, making the gain seem higher. In consideration of the known gain of a half-wave dipole, 0 dBd is defined as 2.15 dBi; all gains in "dBi" are shifted 2.15 higher than gains in "dBd".
Two element dipole array in front of a one wavelength square reflector used as gain standard. The gain of practical array antennas is limited to about 25–30 dB. Two half wave elements spaced a half wave apart and a quarter wave from a reflecting screen have been used as a standard gain antenna with about 9.8 dBi at its design frequency. [4]
A log-periodic antenna (LPDA) consists of many dipole elements of decreasing length, all of which are driven. However, because they are different lengths, only one of the many dipoles is resonant at a given frequency, so only one is driven at a time. The dipole that is driven depends on the frequency of the signal.
A balun / ˈ b æ l ʌ n / (from "balanced to unbalanced", originally, but now derived from "balancing unit") [1] is an electrical device that allows balanced and unbalanced lines to be interfaced without disturbing the impedance arrangement of either line. [2] A balun can take many forms and may include devices that also transform impedances ...
The monopole antenna is essentially one half of the half-wave dipole, a single 1 / 4 wavelength element with the other side connected to ground or an equivalent ground plane (or counterpoise). Monopoles, which are one-half the size of a dipole, are common for long-wavelength radio signals where a dipole would be impractically large.
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The dipole's ends are close, but do not touch, and the ends on either side of the gap may be flared out to form a larger air gap capacitor, whose spacing is used to fine-adjust the antenna's resonant frequency. Most often halos are mounted horizontally, resulting in the antenna's radiation being horizontally polarized and very nearly ...
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω , non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.