Ads
related to: can you clean your oxygen sensor
Search results
Results From The WOW.Com Content Network
The type of oxygen sensor used in most underwater diving applications is the electro-galvanic oxygen sensor, a type of fuel cell, which is sometimes called an oxygen analyser or ppO 2 meter. They are used to measure the oxygen concentration of breathing gas mixes such as nitrox and trimix . [ 9 ]
Some oxygen sensing instruments have the ability to give an alarm signal or close down the welding operation, when there is an unwanted rise in oxygen level. [17] Purging can continue until the oxygen level is low enough once more and welding can begin again. To avoid such situations, undesirable materials must be kept away from the weld zone.
Storage at low oxygen partial pressure when not in use would seem an effective way to extend cell life, but when stored in anoxic conditions the sensor current will cease and the surface of the electrode may be passivated, which can lead to sensor failure. High ambient temperatures will increase sensor current, and reduce cell life.
Us Weekly has affiliate partnerships so we may receive compensation for some links to products and services. Please note: Information below is not intended to diagnose, treat, cure or prevent any ...
When a MAF sensor is used in conjunction with an oxygen sensor, the engine's air/fuel ratio can be controlled very accurately. The MAF sensor provides the open-loop controller predicted air flow information (the measured air flow) to the ECU, and the oxygen sensor provides closed-loop feedback in order to make minor corrections to the predicted ...
Partial pressure blending is done by decanting oxygen and helium into the diving cylinder and then topping up the mix with air from a diving air compressor. To ensure an accurate mix, after each helium and oxygen transfer, the mix is allowed to cool, its pressure is measured and further gas is decanted until the correct pressure is achieved ...