When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Data-rate units - Wikipedia

   en.wikipedia.org/wiki/Data-rate_units

   The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...

3. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   20 MB/s: SD (High Speed) 200 Mbit/s: 25 MB/s: Ultra DMA ATA 33: 264 Mbit/s: 33 MB/s: 1998 Ultra Wide SCSI (16 bits/20 MHz) 320 Mbit/s: 40 MB/s: Ultra-2 SCSI 40 (Fast-40 SCSI) (8 bits/40 MHz) 320 Mbit/s: 40 MB/s: SDHC/SDXC/SDUC (UHS-I Full Duplex) 400 Mbit/s: 50 MB/s: Ultra DMA ATA 66: 533.6 Mbit/s: 66.7 MB/s: 2000 Blu-ray Controller (16×) 576 ...

4. List of countries by Internet connection speeds - Wikipedia

   en.wikipedia.org/wiki/List_of_countries_by...

   This is a list of countries by Internet connection speed for average and median data transfer rates for Internet access by end-users. The difference between average and median speeds is the way individual measurements are aggregated.

5. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   The 100 in the media type designation refers to the transmission speed of 100 Mbit/s, while the BASE refers to baseband signaling. The letter following the dash ( T or F ) refers to the physical medium that carries the signal (twisted pair or fiber, respectively), while the last character ( X , 4 , etc.) refers to the line code method used.

6. Optical Carrier transmission rates - Wikipedia

   en.wikipedia.org/wiki/Optical_Carrier...

   OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...

7. Memory bandwidth - Wikipedia

   en.wikipedia.org/wiki/Memory_bandwidth

   The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.