Ad
related to: danfoss single channel programmer
Search results
Results From The WOW.Com Content Network
Single/Multi Channel Simulcast is the simultaneous transmission of an amplitude modulated and Digital Radio Mondiale (DRM) in the same (SingleChannel Simulcast - SCS) or a neighbouring channel (MultiChannel Simulcast - MCS). To produce this SCS multiplex signal, the initial carrier is modulated by the DRM signal using quadrature phase modulation.
The first use of channel I/O was with the IBM 709 [2] vacuum tube mainframe in 1957, whose Model 766 Data Synchronizer was the first channel controller. The 709's transistorized successor, the IBM 7090, [3] had two to eight 6-bit channels (the 7607) and a channel multiplexor (the 7606) which could control up to eight channels.
The programmer may examine the state of the program, machine, and related data before and after execution of a particular line of code. This allows the programmer to evaluate the effects of each statement or instruction in isolation, and thereby gain insight into the behavior (or misbehavior) of the executing program.
In computer networking, single-channel architecture (SCA) is the design of a wireless network in such a way that the wireless client sees a single point of access to the network. This design utilizes a centralized controller to decide which access point (AP) will be used to communicate with a client device.
The full-duplex capability makes SPI very simple and efficient for single main/single sub applications. Some devices use the full-duplex mode to implement an efficient, swift data stream for applications such as digital audio , digital signal processing , or telecommunications channels , but most off-the-shelf chips stick to half-duplex request ...
JTAG (named after the Joint Test Action Group which codified it) is an industry standard for verifying designs of and testing printed circuit boards after manufacture.. JTAG implements standards for on-chip instrumentation in electronic design automation (EDA) as a complementary tool to digital simulation. [1]
FICON (Fibre Connection) is the IBM proprietary name for the ANSI FC-SB-3 Single-Byte Command Code Sets-3 Mapping Protocol for Fibre Channel (FC) protocol.It is a FC layer 4 protocol used to map both IBM's antecedent (either ESCON or parallel Bus and Tag) channel-to-control-unit cabling infrastructure and protocol onto standard FC services and infrastructure.
In the real world some low-end devices may only support a subset of these 488.2 commands, or may even accept the commands but not perform any operation. A user should check the official programmers manual for each device before assuming all of these 488.2 commands are supported.