Ads
related to: difference between g6.35 and gy6.35 bulb socket
Search results
Results From The WOW.Com Content Network
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
GU5.3, GX5.3, GY5.3, GZ5.3 – same as G5.3 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G6.35 – 6.35 mm (0.25 in)spacing GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing
Slim lamps. Power ratings and lengths not standardized (and not the same) between different manufacturers T5 T16 5 ⁄ 8: 15.9 G5 bi-pin; 2GX13 quad-pin; G10q quad-pin; Original 4–13 W miniature fluorescent range from 1950s or earlier. [1] Two newer ranges, high-efficiency (HE) 14–35 W, and high-output (HO) 24–80 W, introduced in the ...
[Note 2] If a lamp has a "G" code, [Note 3] this will mean the lamp is a bipin shape and the number following the G will indicate the distance in millimeters between the pins, usually either 4, 6.35 or 10; if the G is followed by a letter "Y", then the lamp's pins are thicker than normal— thus, a G6.35 has pins that are 1 mm in diameter but a ...
Similar US bulb: HB2 (9003) 12V: ECE nominal luminous flux: 1,650 / 1,000 lm ±15% Available with P45t base to upgrade old headlamps designed for R2 bulb H7 1 12 V: 55 W 24 V: 70 W PX26d USA, Japan 12V: ECE nominal luminous flux: 1,500 lm ±10% H8 1 12 V: 35 W PGJ19-1 USA ECE nominal luminous flux: 800 lm ±15% H8B 1 12 V: 35 W PGJY19-1 USA H9 1
Plugs according to T11 and T21 are between 13 mm and 14.5 mm wide, those according to T13 and T23 between 14.5 mm and 20 mm wide. Connector according to T11 and T13 between 35 mm and 36 mm long. The respective angles are 45 degrees. Three-phase plugs have a dimension of 35.4 (± 0.7) × 30 (± 0.7) mm. Pin length of the connector
In the case of the 50/100/150 W bulb, putting this bulb in a regular lamp socket will result in it behaving like a normal 100 W bulb. [citation needed] A key switch 3-way socket has the switch incorporated in the lamp socket and requires no external wiring between switch and socket. This would be typical in a 3-way floor-standing floor lamp.
These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...