Search results
Results From The WOW.Com Content Network
VLAN cross connect (CC or VLAN-XC) is a mechanism used to create Switched VLANs, VLAN CC uses IEEE 802.1ad frames where the S Tag is used as a Label as in MPLS. IEEE approves the use of such a mechanism in part 6.11 of IEEE 802.1ad-2005 .
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of Virtual Local Area Networks on the whole local area network. [1] To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Broadcast traffic is used to transmit a message to any reachable destination in the network without the need to know any information about the receiving party. When broadcast traffic is received by a network switch it is replicated to all ports within the respective VLAN except the one from which the traffic comes from.
Private VLAN, also known as port isolation, is a technique in computer networking where a VLAN contains switch ports that are restricted such that they can only communicate with a given uplink. The restricted ports are called private ports. Each private VLAN typically contains many private ports, and a single uplink.
IEEE 802.1ah is an amendment to the IEEE 802.1Q networking standard which adds support for Provider Backbone Bridges.It includes an architecture and a set of protocols for routing over a provider's network, allowing interconnection of multiple provider bridge networks without losing each customer's individually defined VLANs.
The QoS technique developed by the working group, also known as class of service (CoS), is a 3-bit field called the Priority Code Point (PCP) within an Ethernet frame header when using VLAN tagged frames as defined by IEEE 802.1Q. It specifies a priority value of between 0 and 7 inclusive that can be used by QoS disciplines to differentiate ...