Search results
Results From The WOW.Com Content Network
The remaining terminal is what is known as "common". In this example, the signal enters the gate, and exits the drain. The only terminal remaining is the source. This is a common-source FET circuit. The analogous bipolar junction transistor circuit may be viewed as a transconductance amplifier or as a voltage amplifier.
Complementary JFET duals are also noted for their low equivalent noise voltage, high operating voltage, thermal tracking characteristics, low offset voltage, low pinch-off voltages, low input bias currents, and very high input impedance. All of these characteristics make these devices ideal for use in high performance audio, sensor and ...
When referring to a junction field-effect transistor (JFET), the threshold voltage is often called pinch-off voltage instead. [ 1 ] [ 2 ] This is somewhat confusing since pinch off applied to insulated-gate field-effect transistor (IGFET) refers to the channel pinching that leads to current saturation behavior under high source–drain bias ...
For example, V GS(off) for the Temic J202 device varies from −0.8 V to −4 V, [12] while the V GS(off) for the J308 varies between −1 V and −6.5 V. [13] Confusingly, the term pinch-off voltage is also used to refer to the V DS value that separates the linear and saturation regions.
Top: source, bottom: drain, left: gate, right: bulk. Voltages that lead to channel formation are not shown. In field-effect transistors (FETs), depletion mode and enhancement mode are two major transistor types, corresponding to whether the transistor is in an on state or an off state at zero gate–source voltage.
The drain-to-source resistance of the JFET (R DS) and the drain resistor (R 1) form the voltage-divider network. The output voltage can be determined from the equation V out = V DC · R DS / (R 1 + R DS). An LTSpice simulation of the non-linearized VCR design verifies that the JFET resistance changes with a change in gate-to-source voltage (V ...
Channel length modulation (CLM) is an effect in field effect transistors, a shortening of the length of the inverted channel region with increase in drain bias for large drain biases. The result of CLM is an increase in current with drain bias and a reduction of output resistance. It is one of several short-channel effects in MOSFET scaling.
In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an AC ground), or "common," hence its name. The analogous bipolar junction transistor circuit is the common-base amplifier.