Ads
related to: dual gate mosfet theory- High and low side drivers
For motor drives and SMPS
Buy now!
- Selection Guide
View our product offering
The right driver makes a difference
- Learn and Collaborate
Infineon Developer Community
Join the discussion!
- Training
Watch latest training videos
Find out more!
- High and low side drivers
Search results
Results From The WOW.Com Content Network
FlexFET is a planar, independently double-gated transistor with a damascene metal top gate MOSFET and an implanted JFET bottom gate that are self-aligned in a gate trench. . This device is highly scalable due to its sub-lithographic channel length; non-implanted ultra-shallow source and drain extensions; non-epi raised source and drain regions; and gate-last fl
A dual-gate MOSFET often functions as a "one-transistor" cascode [citation needed]. Common in the front ends of sensitive VHF receivers, a dual-gate MOSFET is operated as a common-source amplifier with the primary gate (usually designated "gate 1" by MOSFET manufacturers) connected to the input and the second gate grounded (bypassed ...
The MOSFET is also capable of handling higher power than the JFET. [35] The MOSFET was the first truly compact transistor that could be miniaturised and mass-produced for a wide range of uses. [6] The MOSFET thus became the most common type of transistor in computers, electronics, [36] and communications technology (such as smartphones). [37]
A double-gate FinFET device. A fin field-effect transistor (FinFET) is a multigate device, a MOSFET (metal–oxide–semiconductor field-effect transistor) built on a substrate where the gate is placed on two, three, or four sides of the channel or wrapped around the channel (gate all around), forming a double or even multi gate structure.
The dual-gate MOSFET has a tetrode configuration, where both gates control the current in the device. It is commonly used for small-signal devices in radio frequency applications where biasing the drain-side gate at constant potential reduces the gain loss caused by Miller effect , replacing two separate transistors in cascode configuration.
Metal–oxide–semiconductor field-effect transistor (MOSFET), showing gate (G), body (B), source (S) and drain (D) terminals. The gate is separated from the body by an insulating layer (white). A transistor is a semiconductor device used to amplify or switch electrical signals and power. It is one of the basic building blocks of modern ...
In a depletion-mode MOSFET, the device is normally on at zero gate–source voltage. Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example). For N-type depletion-load devices, the threshold voltage might be about −3 V, so it could be turned off by pulling the gate 3 V negative (the drain, by ...
MOSFET, showing gate (G), body (B), source (S), and drain (D) terminals. The gate is separated from the body by an insulating layer (pink).. The MOSFET (metal–oxide–semiconductor field-effect transistor) [1] is a type of insulated-gate field-effect transistor (IGFET) that is fabricated by the controlled oxidation of a semiconductor, typically silicon.
Ad
related to: dual gate mosfet theory